Single innovations in temperature control technology
October 30, 2010
At its stand, Single Tempreriertechnik (represented in Spain by helmut roegele) performs live presentations showing the beneficial effects of the temperature controls alternate in the quality of the moulding of parts and the cycles of time. Another point of interest is the system of distribution of water Single SWV with driver SC, an economical alternative to the mediores of flow and methods of cooling throbbing.
Single presents a wide range of systems of oil and water pressure, with optimal heating capacities for 144 kW at temperatures above 350 ° c. In addition, Single provides extensive engineering to cover the entire processing chain from a single source; from the original concept of the product, its design and production, through to the final assembly of the technology of control systems of temperature, going through the initial operation and installation. K 2010. K 2010, the company will present a varied sample of oil or water-based control of temperature or cooling systems.
Control at higher temperatures
Single is the circulating of preference means water, the conductivity of heat and its transfer of the same properties are superior to the oil. Used as a means of temperature control, water also serves to processes clean room. Single water systems have been used already successfully above the atmospheric boiling point 100 ° C. The new control systems allow you to use it up to 225 ° C, and it covers all the requirements demanded by more advanced production in molding processes by injection, such as applications for medical engineering. This very compact unit has a capacity of heating of 6kW and a flow of up to 39 litres per minute capacity has been built with high quality components
Control of temperature in microcomponentes
The new water-cooled Micro temperature control system is especially designed for the temperature control of the injection mould tools using micro-canales with a diameter of between 1 and 3 mm. Bottle is a system of temperature control of moulding that allows alternate between hot and cold transfer a system very popular among manufacturers of plastic because of its beneficial effect on the quality of the components.
Single presents the K 2010 alternating temperature control systems both assets and liabilities. Stand there will be demonstrations of the technology of active alternative temperature (ATT, for its acronym in English). The passive system of Single is called EcoTemp and is a highly cost-effective solution.